Channel Grate Sloted Galv Steel

Male and Female Transition Devices (699F & 699M) are available
where channel runs are in opposite directions and two channels
are set either female to female or male to male. A female
transition piece (699F) is used to fill the top space of the female
to female joint (this applies to 600 Series only). An epoxy grout
or urethane sealer can be used to smooth over the gap on the
inside bottom of the channel. A male transition piece (699M) is
used to lap under the male to male joint.

NCI SKU: AC5700

Grate hold-down devices are to be used with all grating systems where wheel traffic occurs. This is necessary to provide system integrity

NCI SKU: AC5692

Male and Female Transition Devices (699F & 699M) are available
where channel runs are in opposite directions and two channels
are set either female to female or male to male. A female
transition piece (699F) is used to fill the top space of the female
to female joint (this applies to 600 Series only). An epoxy grout
or urethane sealer can be used to smooth over the gap on the
inside bottom of the channel. A male transition piece (699M) is
used to lap under the male to male joint.

NCI SKU: AC5705

POLYCAST® DG0670 Grate is a high density polyethylene slotted
grate appropriate for corrosive applications or where sanitary
conditions are necessary. Provides excellent chemical resistance
and durability. Polyethylene construction helps protect bare feet.
Grating locking device Part No. DA0642 (not shown) should be
used and maintained secure. The grate has 18% (18 in²) of open
area. The grate weighs approximately 4lbs [1.81kg] and is only
available in 24″ [610mm] length.

Open Area: 11 in2 /Linear Foot
Dimensions: 5-1/4” x 24”
Weight: 4 lbs.
Slot Size: 0.32″ x 2.95″
NOTE: Part No. DG0670G
available, color: gray

NCI SKU: AC5678