Additional information
| Options |
|---|
Channel Installation-Chair
$13.58
The POLYCAST
Installation Chair is
the most efficient and
economical means of setting
a precast trench system. The
installation chair supports the ends of
the channels, aligns and locks the joint rigidly
together, and prevents the channels from floating.
Adjusting channel elevation is easy with the
POLYCAST Installation Chair.
NCI SKU: AC5683
Related Products
Channel 48″ Neutral Section
Cast-in dimples at bottom of channel to attach installation chair
NCI SKU: AC5490
Channel End Cap Close Outlet
POLYCAST® DG0670 Grate is a high density polyethylene slotted
grate appropriate for corrosive applications or where sanitary
conditions are necessary. Provides excellent chemical resistance
and durability. Polyethylene construction helps protect bare feet.
Grating locking device Part No. DA0642 (not shown) should be
used and maintained secure. The grate has 18% (18 in²) of open
area. The grate weighs approximately 4lbs [1.81kg] and is only
available in 24″ [610mm] length.
Open Area: 11 in2 /Linear Foot
Dimensions: 5-1/4” x 24”
Weight: 4 lbs.
Slot Size: 0.32″ x 2.95″
NOTE: Part No. DG0670G
available, color: gray
NCI SKU: AC5678
Channel Female Adaptor
Male and Female Transition Devices (699F & 699M) are available
where channel runs are in opposite directions and two channels
are set either female to female or male to male. A female
transition piece (699F) is used to fill the top space of the female
to female joint (this applies to 600 Series only). An epoxy grout
or urethane sealer can be used to smooth over the gap on the
inside bottom of the channel. A male transition piece (699M) is
used to lap under the male to male joint.
NCI SKU: AC5705
Channel End Cap Closed
Drain end caps are available for 3” PVC pipe. Solid end caps are also available toseal off the ends of the channels.
NCI SKU: AC5663
Channel Male Adapter
Male and Female Transition Devices (699F & 699M) are available
where channel runs are in opposite directions and two channels
are set either female to female or male to male. A female
transition piece (699F) is used to fill the top space of the female
to female joint (this applies to 600 Series only). An epoxy grout
or urethane sealer can be used to smooth over the gap on the
inside bottom of the channel. A male transition piece (699M) is
used to lap under the male to male joint.
NCI SKU: AC5700
Channel Lock Device F/Ci Grate
Open Area: 19.8 in2
/Linear Foot Dimensions: 5-1/4” x 24”
Weight: 15 lbs.
Slot Size: 0.50″ x 4.19″
NCI SKU: AC5695
Channel End Cap Close Inlet
POLYCAST® Universal Male End Caps are used to enclose or provide 4” pipe inlets to the female channel ends. Inlets accommodate 4” pipes.
NCI SKU: AC5665
Reviews
There are no reviews yet.