Dry Small Diameter Segmented Blades
Call for price
Premium Blades – Designed with a high diamond concentration and a .250 diamond bearing area. Excellent for longer blade life, critical cutting, lowest overall cutting cost and large jobs.General purpose for cutting medium hard masonry materials such as cured concrete, brick, stone, concrete pavers and concrete roofing tiles. Ideal for tuck-pointing mortar joints with medium hard aggregate and medium sand.
NAILS CASE HARD CUT #10 50-LB.
3 inch length
Approx. 78 each per pound
Hardened steel with blunt point and tapered shank cause minimal spalling during penetration and offers even greater pull-out resistance than wire masonry nails. Ideal for attaching wood members to cinder block walls as well as to fresh concrete.
NCI SKU: EN1015
KOOL-ROD – Backer Rod for Cold-Applied Sealants
KOOL-ROD is a closed cell, polyethylene, flexible, rope-like foam joint backing material. This material is virtually non-absorbent and chemically inert to most solvents. KOOL-ROD will not stain or adhere to sealant materials. It is fully compatible with acrylic, butyl, polyurethane, polysulfide, silicone, and most other cold-applied sealant compounds. KOOL-ROD is specifically designed as a compressible backing material to be used in conjunction with a wide variety of cold-applied joint sealants.
- Controls depth of sealant/Ensures proper joint design ratio.
- Forces sealant against joint sidewalls/Provides maximum sidewall adhesion.
- Sealants will not adhere to KOOL-ROD/ Eliminates three-sided joint adhesion failure.
- Closed-cell foam technology/Does not allow air or moisture entrapment.
- Easily compressible, lightweight/Installs quickly, stays in place.
- Easy to handle, smaller packaging/Added contractor convenience.
36″ Lute head with 7′ handle
Use an asphalt lute to ensure that asphalt is spread quickly and evenly. Level and smooth asphalt with a variety of head and handle options. Order complete tool or individual replacement components separately. The handle is made of light weight magnesium. A slightly thinner wall thickness on our economy grade line reduces the overall weight while the slightly larger handle diameter assures reasonable strength against bending. A slightly smaller handle diameter on our premium grade line allows hands to relax more while working and allows a heavier wall thickness to resist bending, without increasing the weight of the lute. No angle braces are needed. The end is capped with a rubber tip. The head is made of wear-resistant aluminum alloy. Aluminum alloy holds heat better, making scrape off easier and teeth will not bend easily as with magnesium heads. An 1/8” thick tee-beam has a smooth edge on one side and serrated edge on the other. The smooth edge is used for final finishing pass leaving asphalt ready for compaction. The serrated edge has blunted teeth with rounded notches, permitting mix to flow through easily without “gumming up.” Standard head is serrated with a full tooth at each end. An un-serrated head with a smooth edge on both sides is available upon request.
SurePoxy HM is a 100% solids, two-component, moisture-insensitive, epoxy resin system. It is an all purpose, very high strength rigid adhesive designed for structural bonding of dry and damp materials free of standing water. It can be applied at temperatures as low as 50 degrees Fahrenheit. Meets: ASTM C-881 Types I, II, IV and V, Grade 2, Class C.