GLOVE LIME LINED WATERPROOF #9
$13.44
Related Products
Brush White Wash, No handle
- Soft tampico bristles spread out wallpaper without scratches or folds
- Two rows of bristles with 2-1/2″ trim are set in 8″ hardwood block with tapered handle hole
- Order handle separately
Stripe Water Base Inverted Tip Marker
A fast drying permanent marking paint applied in an inverted position. Produces vivid lines and is safe on grass. This non-clogging formulation will not wash away. Comes with Seymour’s patented tear away spray-thru cap. Lead free colors. Meets APWA color standards. VOC Compliant. May be sprayed by hand or with the Z-605 marking gun or Z-606 marking wand. As a responsible corporate citizen, Seymour of Sycamore is thoroughly committed to protecting the natural environment and ensuring the well-being of our employees. This means not only providing a safe, clean and healthy workplace, but also fulfilling our legal and social responsibilities within the community. Seymour has developed coatings with waterborne and high-solids resins as an alternative to traditional solvent-based polymers. Seymour products do not contain lead, cadmium, mercury, chromates or chlorinated solvents.
Lime Ripstop Bomber Jacket
- Durable waterproof seam sealed ripstop shell with fleece body & hood
- Hood fits into the collar or can be removed altogether
- Quilted sleeves for easy in and out arm access
- 2″ wide reflective material
- Adjustable cuffs with rubber pulls for easy use when wearing gloves
- Left and right chest mic tabs
- Right chest vertical pocket for wallet or other accessories
- Large left radio pocket
- Left and right outside slash pockets
- Left bicep 2-division pencil/pen pocket with drainage grommets
- Large vertical tablet pocket with zipper inside storm flap. Tablet can be accessed without unzipping the jacket
SurePoxy LM
SurePoxy LM is 100% solids, two- component, moisture-insensitve, epoxy resin system. It is a low modulus, flexible binder that allows for variations in temperature and stress. Meets: ASTM C-881 Types I and II, Grade 2, Class C
NAILS CASE HARD CUT #10 50-LB.
3 inch length
5/16″ head
Fluted
Approx. 78 each per pound
Hardened steel with blunt point and tapered shank cause minimal spalling during penetration and offers even greater pull-out resistance than wire masonry nails. Ideal for attaching wood members to cinder block walls as well as to fresh concrete.
NCI SKU: EN1015
Asphalt Lute
36″ Lute head with 7′ handle
Use an asphalt lute to ensure that asphalt is spread quickly and evenly. Level and smooth asphalt with a variety of head and handle options. Order complete tool or individual replacement components separately. The handle is made of light weight magnesium. A slightly thinner wall thickness on our economy grade line reduces the overall weight while the slightly larger handle diameter assures reasonable strength against bending. A slightly smaller handle diameter on our premium grade line allows hands to relax more while working and allows a heavier wall thickness to resist bending, without increasing the weight of the lute. No angle braces are needed. The end is capped with a rubber tip. The head is made of wear-resistant aluminum alloy. Aluminum alloy holds heat better, making scrape off easier and teeth will not bend easily as with magnesium heads. An 1/8” thick tee-beam has a smooth edge on one side and serrated edge on the other. The smooth edge is used for final finishing pass leaving asphalt ready for compaction. The serrated edge has blunted teeth with rounded notches, permitting mix to flow through easily without “gumming up.” Standard head is serrated with a full tooth at each end. An un-serrated head with a smooth edge on both sides is available upon request.
Reviews
There are no reviews yet.