SurePoxy LM
$161.07
SurePoxy LM is 100% solids, two- component, moisture-insensitve, epoxy resin system. It is a low modulus, flexible binder that allows for variations in temperature and stress. Meets: ASTM C-881 Types I and II, Grade 2, Class C
Related Products

Lime Brilliant Series Bomber Jacket
- Durable water proof and seam sealed shell
- Removable black quilted liner
- Hidden collar hood
- 2” wide 3M™ Scotchlite™
- Reflective Material with 3” contrast
- Reflective piping on collar, shoulders, hood and sleeve seams
- Adjustable cuffs
- Black bottom front and cuffs for durability
- Left chest radio pocket
- Two outside lower slash pockets with zippers
- Inside wallet pocket

SurePoxy HM
SurePoxy HM is a 100% solids, two-component, moisture-insensitive, epoxy resin system. It is an all purpose, very high strength rigid adhesive designed for structural bonding of dry and damp materials free of standing water. It can be applied at temperatures as low as 50 degrees Fahrenheit. Meets: ASTM C-881 Types I, II, IV and V, Grade 2, Class C.

Bolt Cutter

KOOL-ROD – Backer Rod for Cold-Applied Sealants
KOOL-ROD is a closed cell, polyethylene, flexible, rope-like foam joint backing material. This material is virtually non-absorbent and chemically inert to most solvents. KOOL-ROD will not stain or adhere to sealant materials. It is fully compatible with acrylic, butyl, polyurethane, polysulfide, silicone, and most other cold-applied sealant compounds. KOOL-ROD is specifically designed as a compressible backing material to be used in conjunction with a wide variety of cold-applied joint sealants.
- Controls depth of sealant/Ensures proper joint design ratio.
- Forces sealant against joint sidewalls/Provides maximum sidewall adhesion.
- Sealants will not adhere to KOOL-ROD/ Eliminates three-sided joint adhesion failure.
- Closed-cell foam technology/Does not allow air or moisture entrapment.
- Easily compressible, lightweight/Installs quickly, stays in place.
- Easy to handle, smaller packaging/Added contractor convenience.

NAILS CASE HARD CUT #10 50-LB.
3 inch length
5/16″ head
Fluted
Approx. 78 each per pound
Hardened steel with blunt point and tapered shank cause minimal spalling during penetration and offers even greater pull-out resistance than wire masonry nails. Ideal for attaching wood members to cinder block walls as well as to fresh concrete.
NCI SKU: EN1015

BRUSH WHITE WASH
- Use to apply waterproofing, water paints and cement cotaings to concrete blocks
- 5 rows of tampico bristle with 4″ trim length
- 6″ hardwood block with attached red handle
Reviews
There are no reviews yet.